Focusrite Answerbase
The Official Source for Focusrite Product Support and Information
English | German
Glossary Contact Us
Search  
Main Index
 Compatibility
 Current Saffire Range
 Focusrite/Digidesign
 ISA Range
 Liquid Range
 Old Saffire Range
 Saffire
 Headphones
 LEDs
 Saffire Firmware Updater
 Saffire Control Software
 Saffire LE
 Saffire Plugins
 Saffire PRO 10 & 26
 Saffire Range: Compatibility
 Saffire Range: Mac Specific
 Saffire Range: PC Specific
 Platinum Range
 Red Range
 Technical Articles
 Troubleshooting Guides
 User Manuals
Main Index .: Old Saffire Range .: Saffire .: LEDs .: The instrument/line LEDS on my Saffire are both showing 'INST', and I can't select 'LINE'. What do I do?

The instrument/line LEDS on my Saffire are both showing 'INST', and I can't select 'LINE'. What do I do?

Your Saffire may be in Low Power mode. Try to unplug, and reconnect your Saffire's firewire connection. If you are using the external power supply provided, please disconnect this also, before disconnecting the firewire connection to ensure the Saffire reboots properly. If you are not using the external power supply, you may need to connect it before Saffire will boot properly.

Related Articles

article I've got a Mic plugged into the front of my Saffire, and I have no input. Why?
Check that you don't have anything plugged into the instrument/line input on that channel. A jack plugged into the instrument/line input disables the Mic input on that channel. Also, if your mic...
2005-08-01    Views: 3617   
article What are the input impedances of the Pro 14?
Microphone inputs 2k Ohms Line inputs >10k Ohms Instrument inputs 10M Ohms
2010-08-10    Views: 128   
article Are the Octopre line inputs routed through the mic pre circuitry?
The line inputs are not routed through the mic pre amp section but through a line level amp and then through the filter, dynamics and converter. When the 'line' button is pressed in the level knob...
2005-08-03    Views: 1981   
article How much Input Gain can I expect from my ISA 828?
Mic Input Gain With the Mic input selected, the user has access to the full gain range in 10dB steps from 0dB to +60dB (yellow legend). The gain range is split between two gain modes depending...
2007-08-25    Views: 1919   
article The LEDs do not illuminate
- Is the POWER switched on?- Is the correct mains voltage being used for your unit? If not, the fuse may blow, requiring the correct fuse to be refitted. (See Fuse changing in the GENERIC SETUP)
2005-08-03    Views: 2742   


.: Powered by Lore 1.6.3

Copyright 2008 Focusrite Audio Engineering Ltd. All Rights Reserved.