Back to Focusrite.com
Focusrite Answerbase
The Official Source for Focusrite Product Support and Information
English | German
Glossary Contact Us
Search  
Main Index
 Compatibility
 Control 2802
 Current Saffire Range
 Focusrite/Digidesign
 Forte
 ISA Range
 iTrack
 Legacy Saffire Range
 Saffire
 Headphones
 LEDs
 Saffire Firmware Updater
 Saffire Control Software
 Saffire LE
 Saffire Plugins
 Saffire PRO 10 & 26
 Saffire Range: Compatibility
 Saffire Range: Mac Specific
 Saffire Range: PC Specific
 Liquid Range
 Platinum Range
 Plug-ins
 Red Range
 Rednet
 Scarlett USB 2.0 Range
 Technical Articles
 Troubleshooting Guides
 User Manuals
 VRM Box
Main Index .: Legacy Saffire Range .: Saffire .: If there are only 8 analogue outputs, how come there are 5 output pairs available in the lower half of SaffireControl?

If there are only 8 analogue outputs, how come there are 5 output pairs available in the lower half of SaffireControl?

As you can see from the symbol at the bottom of each output pair section, the last pair (9/10) is the SPDIF Output. Also, outputs 5/6 and 7/8 are the same signals as Headphones 1 and Headphones 2 on the front panel respectively.

Related Articles

article Can I use the digital and analogue outputs at the same time?
The analogue outputs are always active and you can use them simultaneously with the digital outputs.
2005-08-02    Views: 4133   
article ISA 828 Analogue outputs.
The ISA 828 has eight balanced analogue outputs which are transmitted via a 25-pin connector that utilises the DB-25FM (TascamTM/Pro ToolsTM) pinout, as follows:
2007-08-29    Views: 3611   
article Can I set up an direct monitor mix for each output?
The SaffireControl PRO allows the setup of one monitor mix which will feed all analogue outputs. The input mixer can set the volume and pan position of all 26 inputs. This mixer does not...
2006-09-26    Views: 5692   
article Is the monitor knob analogue or digital?
The monitor pot on the Scarlett 6i6 does not control the level of the virtual monitor knob in MixControl, it is just an analogue attenuator controlling the volume of the analogue signal going to...
2013-05-08    Views: 91   
article How do the headphone outputs work on the Scarlett 18i20?
The headphone outputs on the 18i20 share their source audio with whatever is assigned to Line Output 7 and 8 (for Headphone Output 1) and Line Output 9 and 10 (for Headphone Output 2). This...
2013-01-10    Views: 949   


.: Powered by Lore 1.6.3

Copyright 2008 Focusrite Audio Engineering Ltd. All Rights Reserved.