Back to Focusrite.com
Focusrite Answerbase
The Official Source for Focusrite Product Support and Information
English | German
Glossary Contact Us
Search  
Main Index
 Compatibility
 Control 2802
 Current Saffire Range
 Focusrite/Digidesign
 Forte
 ISA Range
 iTrack
 Legacy Saffire Range
 Liquid Range
 Platinum Range
 Compounder
 MixMaster
 OctoPre
 Digital
 OctoPre LE
 Penta
 Platinum Digital Options
 ToneFactory
 TrakMaster
 TrakMaster Pro
 TwinTrak Pro
 VoiceMaster
 VoiceMaster Pro
 Plug-ins
 Red Range
 Rednet
 Scarlett USB 2.0 Range
 Technical Articles
 Troubleshooting Guides
 User Manuals
 VRM Box
Main Index .: Platinum Range .: OctoPre .: Digital .: Can I stop the Octopre from defaulting to the same digital card settings every time I turn it on?

Can I stop the Octopre from defaulting to the same digital card settings every time I turn it on?

The Octopre does not have a memory chip in it so it will always turn on with the same bit rate and sample frequency settings. We advise that the Octopre is the first thing to be turned on in a studio set up. Set the freq and bit settings before turning on other gear to avoid noise which could potentially damage monitors.

Related Articles

article What digital options are available for the Octopre LE?
There is only one digital card which can be fitted in the Octopre LE: this gives the unit an 8-channel ADAT Lightpipe input and output. For more information check out the Octopre LE CODEC section...
2005-09-26    Views: 3904   
article Can the ISA 220 remember settings when I turn it off and back on again?
The ISA 220 does not have a memory chip so if you turn it off and back on again, all of the buttons will default to their initial setting.
2005-09-26    Views: 3120   
article I am not sure where the connectors need to go when fitting the ADAT card in my Octopre LE - the instructions do not make it clear. What is the right way?
Check out the updated Installation Instructions for fitting the card. If you still require help then please contact us for further info. This is how the card should look, if installed...
2005-09-26    Views: 3369   
article I can't see the digital output connectors on the back of my new Octopre. What do I need to get?
The Octopre (and other Platinum units) do not come with digital outputs as standard. You can purchase a digital output card which you can be easily fitted into the unit to give you a digital...
2005-08-03    Views: 3352   
article Pin out for the Octopre full spec AD card.
The Pin out for the 9 pin D Sub connector on the Octopre AD card can be found here.
2005-11-22    Views: 4442   


.: Powered by Lore 1.6.3

Copyright 2008 Focusrite Audio Engineering Ltd. All Rights Reserved.