Octopre D Sub connector thread size. .: Focusrite Answerbase

Connecting the Octopre via analogue to an unbalanced system - how to wire the 25 pin connector.
The pinout for the 25 pin line out connector on the Octopre can be found here. The line outputs are balanced so you will need to ensure that the 25 pin connector is wired correctly if you intend...
2005-09-26 Views: 4960

How is the 9-pin / D-Sub connector configured?
The 9-pin D-Sub connector on the 430 MkII ADC card is not a standard 'serial' port and does not send data that a serial port on a computer would receive and understand. It can be switched between...
2005-08-02 Views: 7218

Firewire buffer size cannot be changed in the DAW ASIO control panel
You can change the ASIO buffer size within the DAW set up pages. You cannot change the Firewire buffer size when the DAW is running. This can be done by going to the Windows Start menu > All...
2006-09-29 Views: 11307

The connector from my MixMaster digital board does not fit into the socket on the main board of the unit. What is wrong?
On very early MixMasters the connector between the main board and digital card was different to on the later, standard models. If you have a very early MixMaster but a newer ADC card then you may...
2005-08-08 Views: 4036

Could I use the Penta side chain connector as a second output?
We do not advise this - the best solution is to duplicate the signal with a mixer or splitter box after the main output stage of the Penta. Using clever connections with the side chain jack could...
2005-08-09 Views: 3227

Octopre D Sub connector thread size.

Related Articles