Focusrite Answerbase
The Official Source for Focusrite Product Support and Information
English | German
Glossary Contact Us
Search  
Main Index
 Compatibility
 Current Saffire Range
 Focusrite/Digidesign
 ISA Range
 Liquid Range
 Old Saffire Range
 Platinum Range
 Compounder
 MixMaster
 OctoPre
 OctoPre LE
 Penta
 Platinum Digital Options
 ToneFactory
 TrakMaster
 TrakMaster Pro
 TwinTrak Pro
 VoiceMaster
 VoiceMaster Pro
 Red Range
 Technical Articles
 Troubleshooting Guides
 User Manuals
Main Index .: Platinum Range .: TwinTrak Pro .: There is no sound output from the digital output option.

There is no sound output from the digital output option.

- Is the sample frequency set correctly?
- Is the receiving device set to receive at 24 bit?
- Is the receiving device set to external sync? (See DIGITAL in GENERIC SETUP)
- Is the signal format set correctly, Pro or Consumer, set with jumper J2? (See Platinum A/D card Jumpers section in GENERIC SETUP)

Related Articles

article Can I connect the AES input and output to the SPDIF input and output on my sound card?
In terms of data content there should be no problem connecting between AES and S/PDIF ports. The problem with connecting them arises from signal level issues. An AES signal amplitude is 5V...
2005-08-08    Views: 9281   
article No sound output when using the MIC INPUT.
- Is the power switched on?- Is the LINE switch on the front panel switched out?- Are the INPUT and OUTPUT LEVELS set correctly?- For mics that require phantom power (ie condenser microphones),...
2005-08-03    Views: 3797   
article How can I use the Loopback feature on the PRO 14 to route the output directly to the input?
This video will guide you through the necessary steps to record audio from one application to another using the loopback feature of your Pro 14:
2010-08-11    Views: 171   
article I can't see the digital output connectors on the back of my new Octopre. What do I need to get?
The Octopre (and other Platinum units) do not come with digital outputs as standard. You can purchase a digital output card which you can be easily fitted into the unit to give you a digital...
2005-08-03    Views: 2228   
article The output meters on my VoiceMaster Pro are showing a good level but the signal is clipping my sound card input. What is going on?
We suggest that to get a good output level the gain on the VoiceMaster Pro should be set so that the signal peaks at -6 to -4dB on the output meter. The VMPro meters are calibrated in dBFS, where...
2005-08-04    Views: 2960   


.: Powered by Lore 1.6.3

Copyright 2008 Focusrite Audio Engineering Ltd. All Rights Reserved.