Can I make the LEDs on my Octopre less bright? .: Focusrite Answerbase

I am not sure where the connectors need to go when fitting the ADAT card in my Octopre LE - the instructions do not make it clear. What is the right way?
Check out the updated Installation Instructions for fitting the card. If you still require help then please contact us for further info. This is how the card should look, if installed...
2005-09-26 Views: 3370

The LEDs do not illuminate
- Is the POWER switched on?- Is the correct mains voltage being used for your unit? If not, the fuse may blow, requiring the correct fuse to be refitted. (See Fuse changing in the GENERIC SETUP)
2005-08-03 Views: 3812

What is the difference between the Octopre and Octopre LE?
Most notable is the pre-amp designs. They are similar in performance but not identical. The original OctoPre is a typical Class A Platinum design, (based around a 737 Rhom transistor) the LE is an...
2005-08-02 Views: 9215

The Mac OS X firmware updater keeps failing. What do I do?
The firmware update has two stages. You will see a progress bar for each stage. Please check the colour of the LINE / INSTR LEDs on the front panel. They should be green before the update. When...
2005-08-03 Views: 7108

Pin out for the Octopre full spec AD card.
The Pin out for the 9 pin D Sub connector on the Octopre AD card can be found here.
2005-11-22 Views: 4442

Can I make the LEDs on my Octopre less bright?

Related Articles