Back to Focusrite.com
Focusrite Answerbase
The Official Source for Focusrite Product Support and Information
English | German
Glossary Contact Us
Search  
Main Index
 Compatibility
 Control 2802
 Current Saffire Range
 FireWire Saffires
 DAW Setup guides
 Dual unit and standalone mode
 Liquid Saffire 56
 Pro Tools 9
 Saffire Mix Control
 Saffire PRO 14
 Saffire PRO 24/PRO 24 DSP
 Saffire PRO 40
 OctoPre MkII
 OctoPre MkII Dynamic
 Saffire 6 USB
 Focusrite/Digidesign
 Forte
 ISA Range
 iTrack
 Legacy Saffire Range
 Liquid Range
 Platinum Range
 Plug-ins
 Red Range
 Rednet
 Scarlett USB 2.0 Range
 Technical Articles
 Troubleshooting Guides
 User Manuals
 VRM Box
Main Index .: Current Saffire Range .: FireWire Saffires .: Dual unit and standalone mode .: Which DAW input/output do I use for which unit in dual unit mode?

Which DAW input/output do I use for which unit in dual unit mode?

The following file contains lookup tables that show which DAW input or output to use for which unit's inputs and outputs for all supported dual unit configurations:

Dual unit crib sheets

Please note: dual unit mode is only available for Saffire Mix Control v1.7 and above.

If you have any questions about dual unit mode or problems with dual unit mode please contact us here and we will be happy to help.

Related Articles

article I'm receiving a message about multiple input/output paths when using dual unit mode with Pro Tools 9
Pro Tools 9 requires each input/output path to have a unique name however when using dual unit mode the input/output names set by the driver are duplicated. In order to resolve this you need to...
2011-08-31    Views: 1656   
article What Sample Rates Are Available In Dual Unit Mode?
Dual Device Support is limited to two devices connected to the same bus at sample rates of 48kHz or below. Using sample rates higher than 48kHz is not supported.
2013-03-20    Views: 214   
article Which units can I combine in dual unit mode?
The following table shows which combinations of 2 units are supported in dual unit mode:   Liquid Saffire 56...
2009-09-09    Views: 7280   
article Can I use all inputs/outputs when using Dual Unit mode with Pro Tools 9/10?
Pro Tools 9 and Pro Tools 10 only allow for the use of a maximum of 32 simultaneous inputs/outputs. For this reason if your input/output count when using two FireWire Saffires exceeds 32, you will...
2011-12-07    Views: 3366   
article Which FireWire port should I use for which device in dual unit mode?
Computer with a single FireWire port Connect one Saffire to the FireWire port on the computer. Connect the second Saffire to the spare FireWire port on the first Saffire. Note that the Saffire...
2009-09-09    Views: 6484   


.: Powered by Lore 1.6.3

Copyright 2008 Focusrite Audio Engineering Ltd. All Rights Reserved.