Back to Focusrite.com
Focusrite Answerbase
The Official Source for Focusrite Product Support and Information
English | German
Glossary Contact Us
Search  
Main Index
 Compatibility
 Control 2802
 Current Saffire Range
 Focusrite/Digidesign
 Forte
 ISA Range
 iTrack
 Legacy Saffire Range
 Liquid Range
 Liquid 4PRE
 Liquid Mix
 Emulations
 Mac Specific
 PC Specific
 Pro Tools
 Snapshots
 The Liquid Channel
 Platinum Range
 Plug-ins
 Red Range
 Rednet
 Scarlett USB 2.0 Range
 Technical Articles
 Troubleshooting Guides
 User Manuals
 VRM Box
Main Index .: Liquid Range .: Liquid Mix .: Mac Specific .: My Liquid Mix is losing connection to my computer during Logic's AU Validation

My Liquid Mix is losing connection to my computer during Logic's AU Validation

Sometimes it is possible for Logic's AU Validation process to cause the Liquid Mix to lose connection to the computer, causing AU Validation to hang and eventually fail.

In some situations, performing a reset of the Liquid Mix hardware (holding down SAVE, LOAD, and GO BACK simultaneously on the unit itself) will cause the unit to reconnect, allowing the AU Validation to complete.

Related Articles

article Saffire Product Troubleshooting - Connection Difficulties
This article will be useful for you if you experiencing one of the following issues: • Saffire product does not connect to the computer. • Firmware updater fails. • You are having problems...
2008-10-06    Views: 76256   
article My Control 2802 isn't communicating properly with my computer
If your computer can see the Control 2802 but data doesn't seem to be getting from one to the other reliably, it could be because of other traffic on your network. If connecting the Control 2802...
2011-04-01    Views: 1462   
article How does the Control 2802 connect to my computer?
The Control 2802 connects to your computer via a standard Ethernet connection (either directly or as part of a wider network) for the transmission of DAW Control data, however this connection does...
2011-03-31    Views: 2748   
article Why does Liquid Mix only run in one processor on my multiprocessor computer?
Multiprocessor support is not implemented by plugins. It is something that is determined by the DAW. For example, the normal convention in Logic is that plugins run exclusively on the secondary...
2006-09-20    Views: 4561   
article Troubleshooting USB interface connection and performance issues
If you are experiencing connectivity or audio performance issues with your USB interface you should follow these general troubleshooting steps to help overcome your issue: General...
2012-02-22    Views: 6120   


.: Powered by Lore 1.6.3

Copyright 2008 Focusrite Audio Engineering Ltd. All Rights Reserved.