If the optional A/D converter card is fitted then you can use a single ADAT
cable to connect from either of the Octopre ADAT
outputs to the ADAT
in of the 002. Make sure that the bit depth and sample frequency are set to the same both in Pro Tools (or any other DAW
you may be using) and on the front of the Octopre (note you can only choose 44.1 or 48KHz when using 8-channel ADAT
Lightpipe). Also ensure that the clock source for the 002 is set to ADAT
If the optional converter card is not fitted then you will need a 25-pin snake with balanced 1/4" jack connectors. Connect this to the line out connector of the Octopre and conect the jacks to input 1-8 of the 002. For channels 5-8, ensure that the nominal input level switches on the 002 are all set to +4.