If you purchased your Liquid Mix after the release of the PC software and drivers, it will include the new Liquid Mix 1.5 DVD for both Mac and PC users. This DVD contains the Liquid Mix software and drivers, Documentation, and Emulation files. If you have an older installer DVD which contains only the Mac software, you will need to download the web installer and emulations here.

If you are installing Liquid Mix from the DVD, it is essential that check for any later updates which may be available on our website here.

Installing Liquid Mix on your PC from the DVD

Follow the steps below to complete installation with the Liquid Mix DVD.

1. Connect the Liquid Mix to your PC. If your firewire port is the smaller 4-pin type, you will also need to connect the Liquid Mix power supply. When Liquid Mix hardware is detected you should see the "Found New Hardware" window appear, as shown below. Leave this window open without pressing "Next" for the time being and move onto step 2.
   
   


2. Insert the Liquid Mix DVD. It should autorun. If you have autorun turned off, you can launch the installer by double clicking on the disc icon. Follow the instructions onscreen. You can customize your installation options, as shown below.
   
   
3. The installer detects the path to your VST plugins directory and sets this as the default location to install the Liquid Mix plugins. If you would like to install the plugins in a different location, you can change this path on the page shown below.
   
   


4. Continue following the onscreen instructions and click "Install" to install the Liquid Mix software. This will copy the Liquid Mix resources to your PC (including the Emulation files). Once this has finished, you will see the driver installation page. At this point you should click "Next" in the "Found New Hardware" window
   
   


5. Windows will now install the driver. This may take a few minutes. When driver installation is complete, you will see the page below. Click "Finish" to finalize the driver installation and then click "Next" on the Installer to complete installation.
   
   


6. Installation is now complete. You will see the page below. Click "Finish" to close the window.