Back to Focusrite.com
Focusrite Answerbase
The Official Source for Focusrite Product Support and Information
English | German
Glossary Contact Us
Search  
Main Index .: ISA Range .: ISA 828 .: ISA 828 Analogue outputs.

ISA 828 Analogue outputs.

The ISA 828 has eight balanced analogue outputs which are transmitted via a 25-pin connector that utilises the DB-25FM (TascamTM/Pro ToolsTM) pinout, as follows:


Related Articles

article If there are only 8 analogue outputs, how come there are 5 output pairs available in the lower half of SaffireControl?
As you can see from the symbol at the bottom of each output pair section, the last pair (9/10) is the SPDIF Output. Also, outputs 5/6 and 7/8 are the same signals as Headphones 1 and Headphones 2...

2005-08-01    Views: 4838   
article Can I use the digital and analogue outputs at the same time?
The analogue outputs are always active and you can use them simultaneously with the digital outputs.

2005-08-02    Views: 4133   
article Is the monitor knob analogue or digital?
The monitor pot on the Scarlett 6i6 does not control the level of the virtual monitor knob in MixControl, it is just an analogue attenuator controlling the volume of the analogue signal going to...

2013-05-08    Views: 90   
article Is the monitor knob analogue or digital?
The monitor pot on the Scarlett 18i8 does not control the level of the virtual monitor knob in MixControl, it is just an analogue attenuator controlling the volume of the analogue signal going to...

2013-05-08    Views: 87   
article I can hear software outputs 1 and 2 on other outputs.
Above the input, S/W mix slider for outputs 3+4, is a switch for either 1/2 or 3/4. This switch either routes the audio from 1+2 or 3+4 to that output. There is a similar switch for the first 10...

2006-09-26    Views: 5539   


.: Powered by Lore 1.6.3

Copyright 2008 Focusrite Audio Engineering Ltd. All Rights Reserved.