Rednet 1 & 2 .: Focusrite Answerbase

Problems streaming audio at 96kHz from Dante Virtual Soundcard
Currently, in order to Dante Virtual Soundcard to pass audio correctly a certain Dante Latency setting must be used in the Dante Virtual Soundcard settings. You must switch off Dante Virtual...
2013-04-26 Views: 92

Audio connections on the Rednet 1 & 2
The analogue line-level inputs and outputs on the Rednet 1 & 2 are made via back panel mounted 25-pin D connectors. The pin connections used follow the Tascam DB25 convention which can be found...
2011-03-17 Views: 1741

Which network cables are suitable for use with Rednet?
A RedNet network requires a Gigabit network infrastructure. The following cable types are permitted: Cat 5e Cat 6 Both shielded and unshielded cables are suitable. As dictated by...
2013-04-25 Views: 48

I can't see metering in RedNet Control
If you find that you have no metering on the graphics in RedNet Control, then this is likely due to a FireWall on your system. You will need to add RedNet Control to the list of exceptions...
2013-04-25 Views: 72

I get a No More Flows error in Dante Controller
This is commonly caused by people using Static IP Addresses and trying to route between Dante Virtual Soundcard and . RedNet uses Bonjour in order to assign IP addresses to elements of the...
2013-04-25 Views: 70

Rednet 1 & 2

Articles