Rednet 4 .: Focusrite Answerbase

Problems streaming audio at 96kHz from Dante Virtual Soundcard
Currently, in order to Dante Virtual Soundcard to pass audio correctly a certain Dante Latency setting must be used in the Dante Virtual Soundcard settings. You must switch off Dante Virtual...
2013-04-26 Views: 126

How can I control the Rednet 4's Preamps?
As well as the hardware controls on the front panel of the Rednet 4, the preamps can also be controlled remotely from the Rednet control software, allowing settings to be adjusted from across the...
2011-03-17 Views: 1220

Audio connections on the Rednet 4
The Rednet 4's 8 input channels have both microphone inputs (on XLR connections) and line level inputs (on a single 25 pin connector adhering to the Tascam DB25 standard). Inputs one and two also...
2011-03-17 Views: 1281

Which network cables are suitable for use with Rednet?
A RedNet network requires a Gigabit network infrastructure. The following cable types are permitted: Cat 5e Cat 6 Both shielded and unshielded cables are suitable. As dictated by...
2013-04-25 Views: 37

I can't see metering in RedNet Control
If you find that you have no metering on the graphics in RedNet Control, then this is likely due to a FireWall on your system. You will need to add RedNet Control to the list of exceptions...
2013-04-25 Views: 61

I get a No More Flows error in Dante Controller
This is commonly caused by people using Static IP Addresses and trying to route between Dante Virtual Soundcard and . RedNet uses Bonjour in order to assign IP addresses to elements of the...
2013-04-25 Views: 62

Rednet 4

Articles