Penta .: Focusrite Answerbase

Penta Troubleshooting Guide
No LEDs illuminate • Is the POWER switched on? • Is the correct mains voltage being used for your unit? If not, the fuse may blow, requiring the correct fuse to be refitted. (Click here to find...
2009-06-28 Views: 1752

Can the Penta be used as a dual-mono compressor? How is the signal routed in the unit?
The Penta can be used either as a mono or a stereo compressor. Both the instrument and mic inputs route signal through only the left channel of the Penta, therefore the signal you should route to...
2005-08-09 Views: 3687

The 'compression' and 'ratio' controls on my Penta seem to have no effect on the signal, regardless of setting. What is wrong?
With the compressor engaged and the compression and ratio knob turned fully clockwise you should see the maximum amount of gain reduction (all LEDs on the gain reduction meter lit when signal is...
2005-08-09 Views: 3348

I find that I have to turn the gain on my Penta up very high to get a good input level. Is there a problem?
There is most likely nothing wrong with your Penta - note that its meters measure in dBFS. This is because there is an optional digital output and it is important to know the clipping point of...
2005-08-08 Views: 3650

Penta Attack & Release Values
Time Settings Preset
2005-08-05 Views: 2901

My Penta does not power on. What can I do?
There is a fuse in a holder on the back of the Penta which may have blown. You can lever the holder out with a flathead screwdriver. Check the fuse to see if it is blown and, if it is, replace it...
2005-08-09 Views: 2801

A few seconds after turning my Penta on I can hear static noise from its outputs. What can I do?
The first thing to do is check that all cables are in good order and are not damaged. Try different sources with the Penta to rule out that it may be the signal source which is causing the noise....
2005-08-09 Views: 3197

Could I use the Penta side chain connector as a second output?
We do not advise this - the best solution is to duplicate the signal with a mixer or splitter box after the main output stage of the Penta. Using clever connections with the side chain jack could...
2005-08-09 Views: 3234

Penta

Articles