If there are only 8 analogue outputs, how come there are 5 output pairs available in the lower half of SaffireControl? .: Focusrite Answerbase

Can I use the digital and analogue outputs at the same time?
The analogue outputs are always active and you can use them simultaneously with the digital outputs.
2005-08-02 Views: 2138

ISA 828 Analogue outputs.
The ISA 828 has eight balanced analogue outputs which are transmitted via a 25-pin connector that utilises the DB-25FM (TascamTM/Pro ToolsTM) pinout, as follows:
2007-08-29 Views: 1887

Can I set up an direct monitor mix for each output?
The SaffireControl PRO allows the setup of one monitor mix which will feed all analogue outputs. The input mixer can set the volume and pan position of all 26 inputs. This mixer does not...
2006-09-26 Views: 2911

Can I use the AES and S/PDIF outputs of the ISA 220 A/D card simultaneously?
We do not advise this since both outputs share the same power source. There is no problem in using one of the digital outputs and the analogue output at the same time however.
2005-09-26 Views: 2394

I can hear software outputs 1 and 2 on other outputs.
Above the input, S/W mix slider for outputs 3+4, is a switch for either 1/2 or 3/4. This switch either routes the audio from 1+2 or 3+4 to that output. There is a similar switch for the first 10...
2006-09-26 Views: 2637

If there are only 8 analogue outputs, how come there are 5 output pairs available in the lower half of SaffireControl?

Related Articles