Focusrite Answerbase - Deutsch
Die offizielle Quelle für schnelle Hilfe und Informationen zu Ihren Focusrite-Produkten
English | German
Glossary Contact Us
Search  
Main Index
 Aktuelle Saffire Baureihe
 Control 2802
 Focusrite/Digidesign
 Forte
 ISA Reihe
 ISA 110 Limited Edition / ISA 215
 ISA 220 Session Pack
 ISA 428 Pre Pack
 ISA 430 MKII Producer
 ISA 828
 ISA Two
 iTrack
 Kompatibilität
 Liquid Reihe
 Manuals und Software
 Platinum Range
 Plug-Ins
 Red Range
 Rednet
 Saffire Reihe
 Scarlett USB 2.0 Baureihe
 Technik bezogene Artikel
 VRM Box
Main Index .: ISA Reihe .: ISA 430 MKII Producer .: How is the 9-pin / D-Sub connector configured?

How is the 9-pin / D-Sub connector configured?

The 9-pin D-Sub connector on the 430 MkII ADC card is not a standard 'serial' port and does not send data that a serial port on a computer would receive and understand. It can be switched between sending AES and S/PDIF digital audio signals. You will most likely need a breakout cable to use it. Focusrite manufacture two different breakout cables - one with XLRs for AES and one with RCA phono connectors for S/PDIF. You can purchase these breakout cables from any Focusrite dealer or distributor.

The pin-out for the cables can be found in this document - ad9pinconfig.pdf

Related Articles

article Connecting the Octopre via analogue to an unbalanced system - how to wire the 25 pin connector.
The pinout for the 25 pin line out connector on the Octopre can be found here. The line outputs are balanced so you will need to ensure that the 25 pin connector is wired correctly if you intend...
2005-09-26    Views: 2657   
article Octopre D Sub connector thread size.
The Octopre connectors use a standard 4-40 thread (most all D Sub connectors will do).
2005-08-03    Views: 1970   
article The connector from my MixMaster digital board does not fit into the socket on the main board of the unit. What is wrong?
On very early MixMasters the connector between the main board and digital card was different to on the later, standard models. If you have a very early MixMaster but a newer ADC card then you may...
2005-08-08    Views: 2193   
article Could I use the Penta side chain connector as a second output?
We do not advise this - the best solution is to duplicate the signal with a mixer or splitter box after the main output stage of the Penta. Using clever connections with the side chain jack could...
2005-08-09    Views: 2123   
article ISA 828 Analogue outputs.
The ISA 828 has eight balanced analogue outputs which are transmitted via a 25-pin connector that utilises the DB-25FM (TascamTM/Pro ToolsTM) pinout, as follows:
2007-08-29    Views: 1884   


.: Powered by Lore 1.6.3

Copyright 2009 Focusrite Audio Engineering Ltd. All Rights Reserved.