I can hear distortion on channels 2,4,6 and 8 - how can I get rid of it? .: Focusrite Answerbase

I can hear distortion when the compressor on my TwinTrak Pro is set to 'hard ratio'. Is there a problem?
Owing to the optical elements in the compressor circuitry, a certain amount of distortion will occur when a lot of compression is applied. This distortion is also dependant on the type of...
2005-08-10 Views: 2128

I have connected my unit via S/PDIF but can only hear digital noise from the SPDIF input on my receiving device. What can I do?
This is most likely to be a sync problem so the first thing to check is that the sample frequency and bit depth are set to the same for the Platinum ADC card and for the receiving device. The...
2005-08-05 Views: 2766

I have my ISA card synced internally but the receiving device looses sync resulting in the signal cutting out/digital distortion. What is wrong?
Check that the receiving device is set to sync to the input to which the 428 is connected and the sample frequency and bit depth settings are the same for both the receiving device and on the ISA...
2005-08-10 Views: 2606

Digital Card Jumper Positions - Disabling Channels 5-8
Four jumpers on the digital card can be made to disable channels 5-8 on the AES Output. This is so that a standard 25-pin to 25-pin Pro ToolsTM cable can be used to record channels 1-4 at 192kHz....
2007-10-15 Views: 1787

The Liquid Channel input level meter is barely registering signal before distortion occurs. What can I check?
Distortion should not be introduced by the Liquid Channel until the O/L LED lights. If this is not the case then make sure the harmonics knob is set to 0, the compressor and EQ are not switched...
2005-09-21 Views: 2417

I can hear distortion on channels 2,4,6 and 8 - how can I get rid of it?

Related Articles