No sound output when using the MIC INPUT. .: Focusrite Answerbase

Can I connect the AES input and output to the SPDIF input and output on my sound card?
In terms of data content there should be no problem connecting between AES and S/PDIF ports. The problem with connecting them arises from signal level issues. An AES signal amplitude is 5V...
2005-08-08 Views: 5505

I can't get any sound from the monitor outputs of my VoiceMaster Pro when using the mic input.
Check the following:Ã¯ Is the power switched on?Ã¯ Is the LINE switch on the front panel switched out?Ã¯ Are the INPUT and OUTPUT LEVELS set correctly?Ã¯ For microphones that require...
2005-08-03 Views: 2503

The output meters on my VoiceMaster Pro are showing a good level but the signal is clipping my sound card input. What is going on?
We suggest that to get a good output level the gain on the VoiceMaster Pro should be set so that the signal peaks at -6 to -4dB on the output meter. The VMPro meters are calibrated in dBFS, where...
2005-08-04 Views: 2712

There is no sound output from the digital output option.
Ã¯ Is the sample frequency set correctly?Ã¯ Is the receiving device set to receive at 24 bit?Ã¯ Is the receiving device set to external sync? (See DIGITAL in GENERIC SETUP)Ã¯ Is the signal format...
2005-08-03 Views: 2649

What is the difference between input mix and cue mix?
Each pair of outputs (1/2 - 9/10) can be assigned its own unique mix of both the four input channels and 10 channels of audio from the recording software in use (Logic, Cubase, etc.). These mixes...
2005-08-01 Views: 3304

No sound output when using the MIC INPUT.

Related Articles