Focusrite Answerbase - Deutsch
Die offizielle Quelle für schnelle Hilfe und Informationen zu Ihren Focusrite-Produkten
English | German
Glossary Contact Us
Search  
Main Index
 Aktuelle Saffire Baureihe
 Control 2802
 Focusrite/Digidesign
 Forte
 ISA Reihe
 iTrack
 Kompatibilität
 Liquid Reihe
 Manuals und Software
 Platinum Range
 Compounder
 MixMaster
 OctoPre
 OctoPre LE
 Penta
 Platinum Digital Options
 ToneFactory
 TrakMaster
 TrakMaster Pro
 TwinTrak Pro
 VoiceMaster
 VoiceMaster Pro
 Plug-Ins
 Red Range
 Rednet
 Saffire Reihe
 Scarlett USB 2.0 Baureihe
 Technik bezogene Artikel
 VRM Box
Main Index .: Platinum Range .: VoiceMaster Pro .: I get a loud burst of noise when turning the phantom power on on my VoiceMaster Pro. Is this normal?

I get a loud burst of noise when turning the phantom power on on my VoiceMaster Pro. Is this normal?

This owing to the capacitors charging and is normal. We suggest making sure your monitors are muted when switching on phantom power or when switching the unit on with phantom power switched in. Note that the VoiceMaster Pro should be the first bit of gear in your set up that you turn on and last you turn off so as to avoid loud signals going through your system whilst it is powered up.

Related Articles

article I get a loud pop through my speakers when I turn my VoiceMaster Pro on and off. Is this normal?
This is normal and you will find that any class A pre amp does this (unless there is a relay circuit to delay the switching of the output - normally found in active speakers). The noise is...
2005-08-05    Views: 2874   
article The Phantom power on my VoiceMaster Pro is not working. What can I do?
Firstly ensure that it is the phantom power and not something else that is causing the problem. Check that the mic and mic cable are not damaged. Use different mics that require phantom power to...
2005-08-05    Views: 2065   
article The phantom power measures at 52V. Is this a problem?
This is perfectly normal for the unit and no damage will be caused to a microphone by the slightly increased voltage.
2005-09-26    Views: 2616   
article A few seconds after turning my Penta on I can hear static noise from its outputs. What can I do?
The first thing to do is check that all cables are in good order and are not damaged. Try different sources with the Penta to rule out that it may be the signal source which is causing the noise....
2005-08-09    Views: 2017   
article Can I use condenser mics and dynamic mics simultaneously with my Octopre LE? Will phantom power damage the dynamic mics?
The phantom power on the Octopre LE is globally switched in and out so if you are recording with condenser mics that require phantom power, any dynamic mics (that do not require phantom) that you...
2005-08-04    Views: 2517   


.: Powered by Lore 1.6.3

Copyright 2009 Focusrite Audio Engineering Ltd. All Rights Reserved.