The connector from my MixMaster digital board does not fit into the socket on the main board of the unit. What is wrong? .: Focusrite Answerbase

I am not sure where the connectors need to go when fitting the ADAT card in my Octopre LE - the instructions do not make it clear. What is the right way?
Check out the updated Installation Instructions for fitting the card.If you still require help then please contact us for further info.This is how the card should look, if installed correctly.
2005-09-26 Views: 2346

I have connected my unit via S/PDIF but can only hear digital noise from the SPDIF input on my receiving device. What can I do?
This is most likely to be a sync problem so the first thing to check is that the sample frequency and bit depth are set to the same for the Platinum ADC card and for the receiving device. The...
2005-08-05 Views: 2768

How is the 9-pin / D-Sub connector configured?
The 9-pin D-Sub connector on the 430 MkII ADC card is not a standard 'serial' port and does not send data that a serial port on a computer would receive and understand. It can be switched between...
2005-08-02 Views: 4190

MixMaster expander is causing the signal to cut out.
If the MixMaster expander section causes the signal to cut out when engaged, and all of the expander meter LEDs light up, then the opto most likely needs replacing. Please contact the distributor...
2005-08-08 Views: 2125

What is the phase meter for on the MixMaster?
The phase meter shows you the phase relationship between the left and right channels. For signals panned centre (mono compatible) this should be 0 so if you are a broadcaster and are engineering a...
2005-08-08 Views: 1947

The connector from my MixMaster digital board does not fit into the socket on the main board of the unit. What is wrong?

Related Articles