Focusrite Answerbase - Deutsch
Die offizielle Quelle für schnelle Hilfe und Informationen zu Ihren Focusrite-Produkten
English | German
Glossary Contact Us
Search  
Main Index
 Aktuelle Saffire Baureihe
 Control 2802
 Focusrite/Digidesign
 Forte
 ISA Reihe
 iTrack
 Kompatibilität
 Liquid Reihe
 Manuals und Software
 Platinum Range
 Compounder
 MixMaster
 OctoPre
 OctoPre LE
 Penta
 Platinum Digital Options
 ToneFactory
 TrakMaster
 TrakMaster Pro
 TwinTrak Pro
 VoiceMaster
 VoiceMaster Pro
 Plug-Ins
 Red Range
 Rednet
 Saffire Reihe
 Scarlett USB 2.0 Baureihe
 Technik bezogene Artikel
 VRM Box
Main Index .: Platinum Range .: Penta .: Could I use the Penta side chain connector as a second output?

Could I use the Penta side chain connector as a second output?

We do not advise this - the best solution is to duplicate the signal with a mixer or splitter box after the main output stage of the Penta. Using clever connections with the side chain jack could result in load problems which may damage the unit. Note also that the side chain output is unprocessed.

Related Articles

article How is the 9-pin / D-Sub connector configured?
The 9-pin D-Sub connector on the 430 MkII ADC card is not a standard 'serial' port and does not send data that a serial port on a computer would receive and understand. It can be switched between...
2005-08-02    Views: 4181   
article Connecting the Octopre via analogue to an unbalanced system - how to wire the 25 pin connector.
The pinout for the 25 pin line out connector on the Octopre can be found here. The line outputs are balanced so you will need to ensure that the 25 pin connector is wired correctly if you intend...
2005-09-26    Views: 2660   
article The 'compression' and 'ratio' controls on my Penta seem to have no effect on the signal, regardless of setting. What is wrong?
With the compressor engaged and the compression and ratio knob turned fully clockwise you should see the maximum amount of gain reduction (all LEDs on the gain reduction meter lit when signal is...
2005-08-09    Views: 2402   
article A few seconds after turning my Penta on I can hear static noise from its outputs. What can I do?
The first thing to do is check that all cables are in good order and are not damaged. Try different sources with the Penta to rule out that it may be the signal source which is causing the noise....
2005-08-09    Views: 2017   
article My Penta does not power on. What can I do?
There is a fuse in a holder on the back of the Penta which may have blown. You can lever the holder out with a flathead screwdriver. Check the fuse to see if it is blown and, if it is, replace it...
2005-08-09    Views: 1806   


.: Powered by Lore 1.6.3

Copyright 2009 Focusrite Audio Engineering Ltd. All Rights Reserved.