Focusrite Answerbase - Deutsch
Die offizielle Quelle für schnelle Hilfe und Informationen zu Ihren Focusrite-Produkten
English | German
Glossary Contact Us
Search  
Main Index
 Aktuelle Saffire Baureihe
 Control 2802
 Focusrite/Digidesign
 Forte
 ISA Reihe
 iTrack
 Kompatibilität
 Liquid Reihe
 Manuals und Software
 Platinum Range
 Compounder
 MixMaster
 OctoPre
 OctoPre LE
 Penta
 Platinum Digital Options
 ToneFactory
 TrakMaster
 TrakMaster Pro
 TwinTrak Pro
 VoiceMaster
 VoiceMaster Pro
 Plug-Ins
 Red Range
 Rednet
 Saffire Reihe
 Scarlett USB 2.0 Baureihe
 Technik bezogene Artikel
 VRM Box
Main Index .: Platinum Range .: TwinTrak Pro .: My TwinTrak Pro gets very hot whn in use. Is this a problem?

My TwinTrak Pro gets very hot whn in use. Is this a problem?

The TTPro gets hot because it uses class A circuitry. The unit is designed to run hot and so the heat is not a problem, even on long sessions, although we do advise to leave space above the unit to allow heat to dissipate. If the unit unit is racked then it is a good idea to leave a 1U space above it.

Related Articles

article I can hear distortion when the compressor on my TwinTrak Pro is set to 'hard ratio'. Is there a problem?
Owing to the optical elements in the compressor circuitry, a certain amount of distortion will occur when a lot of compression is applied. This distortion is also dependant on the type of...
2005-08-10    Views: 2129   
article I can hear hum when using a dynamic mic with the TwinTrak Pro. It gets louder when I engage the 'air' switch. Is something wrong?
Unfortunately this is inevitable - dynamic mics can be good at inducing hum and the inductor circuit activated by the 'air' switch will only make it more audible. Setting the impedance to maximum...
2005-08-09    Views: 2134   
article The phantom power measures at 52V. Is this a problem?
This is perfectly normal for the unit and no damage will be caused to a microphone by the slightly increased voltage.
2005-09-26    Views: 2618   
article I cannot hear the DAC signal with the 'digital insert' button switched out on my TwinTrak Pro. What is wrong?
If the digital insert button is pressed in on the TwinTrak Pro then the signal from the DAC is routed to the channel line inputs. If the digital insert button is pressed out then the DAC signal is...
2005-08-09    Views: 1968   
article I can hear hiss and crackling noises on the headphone output of my TwinTrak Pro. What can I do?
Make sure that nothing is connected to the unit, the headphones mix knob is set fully anti-clockwise and all processing is switched out, then listen to the headphone output. Check to see if the...
2005-08-09    Views: 2726   


.: Powered by Lore 1.6.3

Copyright 2009 Focusrite Audio Engineering Ltd. All Rights Reserved.