I am not sure where the connectors need to go when fitting the ADAT card in my Octopre LE - the instructions do not make it clear. What is the right way? .: Focusrite Answerbase

I can't see the digital output connectors on the back of my new Octopre. What do I need to get?
The Octopre (and other Platinum units) do not come with digital outputs as standard. You can purchase a digital output card which you can be easily fitted into the unit to give you a digital...
2005-08-03 Views: 2210

Connecting an Octopre to a Digi 002.
If the optional A/D converter card is fitted then you can use a single ADAT cable to connect from either of the Octopre ADAT outputs to the ADAT in of the 002. Make sure that the bit depth and...
2005-09-24 Views: 3875

Can I make the LEDs on my Octopre less bright?
Unfortunately not but if you find them too bright then try putting some pieces of masking tape over them (not the markings though) so that they still shine through.
2005-08-04 Views: 1922

I am experiencing clicks and pops with my Octopre LE connected using ADAT Lightpipe. What can I do?
If your Octopre LE is not syncing to your sound card/audio interface or vice versa, or you are hearing clicks and pops in your recordings, then:- Ensure that the ADAT cable(s) is not faulty - try...
2005-09-26 Views: 4583

Setting up your Octopre in a digital audio system.
A Guide to Setting Up Your Digital System Introduction OctoPre cables for connecting the optional A/D cards ADAT lightpipe format...
2005-08-01 Views: 5657

I am not sure where the connectors need to go when fitting the ADAT card in my Octopre LE - the instructions do not make it clear. What is the right way?

Related Articles