Focusrite Answerbase - Deutsch
Die offizielle Quelle für schnelle Hilfe und Informationen zu Ihren Focusrite-Produkten
English | German
Glossary Contact Us
Search  
Main Index
 Aktuelle Saffire Baureihe
 Control 2802
 Focusrite/Digidesign
 Forte
 ISA Reihe
 iTrack
 Kompatibilität
 Liquid Reihe
 Manuals und Software
 Platinum Range
 Compounder
 MixMaster
 OctoPre
 Digital
 OctoPre LE
 Penta
 Platinum Digital Options
 ToneFactory
 TrakMaster
 TrakMaster Pro
 TwinTrak Pro
 VoiceMaster
 VoiceMaster Pro
 Plug-Ins
 Red Range
 Rednet
 Saffire Reihe
 Scarlett USB 2.0 Baureihe
 Technik bezogene Artikel
 VRM Box
Main Index .: Platinum Range .: OctoPre .: Connecting the Octopre via analogue to an unbalanced system - how to wire the 25 pin connector.

Connecting the Octopre via analogue to an unbalanced system - how to wire the 25 pin connector.

The pinout for the 25 pin line out connector on the Octopre can be found here. The line outputs are balanced so you will need to ensure that the 25 pin connector is wired correctly if you intend to route the outputs to an unbalanced system. If you want to wire unbalanced connectors to the other end then here's how (example for one channel):

Connect H pin to tip of connector
Connect C pin to sleeve of connector
Connect G pin to cable shield

Note that the Octopre can accept balanced or unbalanced signals at the line input.

Related Articles

article ISA 828 Analogue outputs.
The ISA 828 has eight balanced analogue outputs which are transmitted via a 25-pin connector that utilises the DB-25FM (TascamTM/Pro ToolsTM) pinout, as follows:
2007-08-29    Views: 1885   
article Setting up your Octopre in a digital audio system.
A Guide to Setting Up Your Digital System Introduction OctoPre cables for connecting the optional A/D cards ADAT lightpipe format...
2005-08-01    Views: 5632   
article Octopre D Sub connector thread size.
The Octopre connectors use a standard 4-40 thread (most all D Sub connectors will do).
2005-08-03    Views: 1973   
article Connecting an Octopre to a Digi 002.
If the optional A/D converter card is fitted then you can use a single ADAT cable to connect from either of the Octopre ADAT outputs to the ADAT in of the 002. Make sure that the bit depth and...
2005-09-24    Views: 3869   
article How is the 9-pin / D-Sub connector configured?
The 9-pin D-Sub connector on the 430 MkII ADC card is not a standard 'serial' port and does not send data that a serial port on a computer would receive and understand. It can be switched between...
2005-08-02    Views: 4182   


.: Powered by Lore 1.6.3

Copyright 2009 Focusrite Audio Engineering Ltd. All Rights Reserved.