ISA 828 Analogue outputs. .: Focusrite Answerbase

If there are only 8 analogue outputs, how come there are 5 output pairs available in the lower half of SaffireControl?
As you can see from the symbol at the bottom of each output pair section, the last pair (9/10) is the SPDIF Output. Also, outputs 5/6 and 7/8 are the same signals as Headphones 1 and Headphones 2...
2005-08-01 Views: 2715

Can I use the digital and analogue outputs at the same time?
The analogue outputs are always active and you can use them simultaneously with the digital outputs.
2005-08-02 Views: 2139

I can hear software outputs 1 and 2 on other outputs.
Above the input, S/W mix slider for outputs 3+4, is a switch for either 1/2 or 3/4. This switch either routes the audio from 1+2 or 3+4 to that output. There is a similar switch for the first 10...
2006-09-26 Views: 2640

Connecting the Octopre via analogue to an unbalanced system - how to wire the 25 pin connector.
The pinout for the 25 pin line out connector on the Octopre can be found here. The line outputs are balanced so you will need to ensure that the 25 pin connector is wired correctly if you intend...
2005-09-26 Views: 2664

How is the signal routed in the Liquid Channel?
After the input stage, the signal gets converted to the digital domain to be processed and then gets converted back to an analogue signal before the analogue output. A pre D/A conversion AES...
2005-08-08 Views: 2683

ISA 828 Analogue outputs.

Related Articles