Focusrite Answerbase - Deutsch
Die offizielle Quelle für schnelle Hilfe und Informationen zu Ihren Focusrite-Produkten
English | German
Glossary Contact Us
Search  
Main Index
 Aktuelle Saffire Baureihe
 Control 2802
 Focusrite/Digidesign
 Forte
 ISA Reihe
 ISA 110 Limited Edition / ISA 215
 ISA 220 Session Pack
 ISA 428 Pre Pack
 ISA 430 MKII Producer
 ISA 828
 ISA 828 Digital Card
 ISA Two
 iTrack
 Kompatibilität
 Liquid Reihe
 Manuals und Software
 Platinum Range
 Plug-Ins
 Red Range
 Rednet
 Saffire Reihe
 Scarlett USB 2.0 Baureihe
 Technik bezogene Artikel
 VRM Box
Main Index .: ISA Reihe .: ISA 828 .: ISA 828 Digital Card .: ISA 828 ADC ADAT Output Configurations

ISA 828 ADC ADAT Output Configurations

The ADATTM output connectors operate as follows:

44.1/48kHz sample rates:
Connector 1 = channels 1 to 8 in parallel
Connector 2 = channels 1 to 8 in parallel (identical to connector 1)

88.2/96kHz sample rates:
Connector 1 = channels 1 to 4
Connector 2 = channels 5 to 8

176.4/192kHz sample rates:
Connector 1 = channels 1 and 2
Connector 2 = channels 3 and 4

Related Articles

article ISA 828 ADC DB25 Pin Out Configurations

2007-10-19    Views: 1477   
article There is no sound output from the digital output option.
ï Is the sample frequency set correctly?ï Is the receiving device set to receive at 24 bit?ï Is the receiving device set to external sync? (See DIGITAL in GENERIC SETUP)ï Is the signal format...
2005-08-03    Views: 2653   
article I am not sure where the connectors need to go when fitting the ADAT card in my Octopre LE - the instructions do not make it clear. What is the right way?
Check out the updated Installation Instructions for fitting the card.If you still require help then please contact us for further info.This is how the card should look, if installed correctly.
2005-09-26    Views: 2342   
article Can I connect the AES input and output to the SPDIF input and output on my sound card?
In terms of data content there should be no problem connecting between AES and S/PDIF ports. The problem with connecting them arises from signal level issues. An AES signal amplitude is 5V...
2005-08-08    Views: 5512   
article I am experiencing clicks and pops with my Octopre LE connected using ADAT Lightpipe. What can I do?
If your Octopre LE is not syncing to your sound card/audio interface or vice versa, or you are hearing clicks and pops in your recordings, then:- Ensure that the ADAT cable(s) is not faulty - try...
2005-09-26    Views: 4576   


.: Powered by Lore 1.6.3

Copyright 2009 Focusrite Audio Engineering Ltd. All Rights Reserved.